Table of Contents
Advertisement
Available languages
Available languages
EN
FR NL SL
back to the manufacturer or returned to
the reseller before being used again.
•
Switch the device off immediately if it is
faulty or if it displays malfunctions.
•
Do not under any circumstances try to
open and/or repair the device yourself!
Repairs must be carried out only by the
after-sales service or approved resellers.
Failure to follow these instructions may
void the warranty.
•
The manufacturer cannot be held respon-
sible for damage caused by inappropriate
or improper use.
report_p Notes on batteries:
•
If the liquid of the battery cell comes into
contact with the skin or eyes, rinse the area
affected with water and consult a doctor.
•
Ingestion hazard! Young children might
swallow the batteries and suffocate. So
keep the batteries out of the reach of
children!
•
If a battery has leaked, put on protective
gloves and clean the battery compartment
with a dry cloth.
•
Protect the batteries from excessive heat.
•
Explosion hazard!Do not throw batteries
onto the fire.
•
Do not attempt to re-charge or short-cir-
cuit the batteries.
•
Remove the batteries from the battery
compartment if the device is not to be
used for a lengthy period.
•
Use only identical or equivalent batteries.
•
Always replace all the batteries at the
same time.
•
Do not use the accumulator!
•
Do not dismantle, open or break the
batteries.
DESCRIPTION OF
THE DEVICE insert_p 1
1 Electro-stimulation mat
2 Main unit
a On/off button
b Button to increase the intensity
c Button to reduce the intensity
d Mode selection button
e USB micro port
3 Remote control
a Off button
b Button to increase the intensity
c Button to reduce the intensity
d Mode selection button
INSTRUCTIONS FOR USE
info_out Notes:
•
We recommend using the Circulation Mat
once a day for 25 minutes ( automatic
timing in each mode).
•
The device has 2 modes and 15 levels of
intensity.
4
English
/ 16
E-IM-CirculationMat-001.indd 4
E-IM-CirculationMat-001.indd 4
•
We would recommend starting with a
weak intensity and increasing the intensity
gradually as you adjust it.
Charging the main battery insert_p 2
1 Connect the USB cable to the main unit
via the USB micro port (Fig. 1, point 3e)
2 Connect the USB cable to the mains us-
ing an adapter (not included) or to a USB
port (for example, on your computer).
3 The LED lamp displays a red light
when charging. A white light indi-
cates that charging is complete.
Preparation insert_p 1
•
Make sure the main unit has been charged
(see above).
•
Fix the main unit (2) to the mat (1) in the
space provided for this purpose.
•
Take off your shoes and socks.
•
Wash or moisturise your feet. Feet that are
dirty or too dry might hinder the feeling
of electrical impulses.
•
Put each of your bare feet on either side
of the mat (1).
Use insert_p 1
•
Press the on/off button of the main unit
(2a) to switch on the device. (1)
info_out Note: The unit can be switched
off by means of the main unit or
the remote control, but can only
be switched on via the main unit.
•
On start-up, the electrostimulation is pro-
grammed for mode 1, intensity 1.
•
Press the mode selection button, either
on the main unit (2d) or on the remote
control (3d) to change mode. Le LED light
will change colour according to the mode
selected: white for mode 1 and green for
mode 2.
•
Press the button for increasing the in-
tensity either on the main unit (2b) or on
the remote control (3b) to increase the
intensity. The LED light will flash once.
•
Press the button for reducing the inten-
sity either on the main unit (2c) or on the
remote control (3c) to reduce the intensity.
The LED light will flash once.
info_out Note: if your feet leave the
mat, the LED light will flash, the
intensity will drop automatically
to level 1 and the device will
turn off after a few seconds.
Programmes
Mode 1: adjustment phase lasting twenty
seconds or so, then toning programme by
intervals.
Mode 2: massage programmes alternating
between vibration and kneading.
Changing the remote
control battery insert_p 3
1 Using your nails, press and pull the
battery compartment located on the
back of the remote control at the same
time, as shown on the diagram.
2 Replace the CR2032 battery.
3 Push the compartment back
inside the remote control.
MAINTENANCE AND STORAGE
Cleaning
•
Before cleaning, remove the batteries
from the device.
•
After each use, clean the device with a soft,
slightly damp cloth. If it is very dirty, you
can use a cloth moistened with a gentle,
soapy detergent.
•
Make sure that the water does not seep
into the device. If this happens, do not use
the device again until it is completely dry.
•
To clean it, do not use any chemical clean-
ing agent or abrasive product.
Storage
•
If you do not intend to use the device
for a long time, disconnect the main unit
from the mat.
•
Store the device in a well ventilated area,
away from heat and humidity.
•
Do not place heavy objects on the device.
BREAKDOWNS AND
SOLUTIONS
sentimen The feeling seems more powerful
in one foot than in the other.
help_out This is completely normal. The
body reacts differently depending
on the areas being treated.
sentimen Make sure that your feet are in
a good position on the mat.
sentimen When in use, you will experience
a burning sensation or
stimulation becomes too weak.
help_out Your feet are not sticking
properly to the mat.
sentimen Apply a few drops of water to
the mat or to your feet.
sentimen Stimulation is uncomfortable.
help_out The intensity is too high.
sentimen Reduce the intensity.
help_out The mat is damaged.
sentimen Contact your supplier's
after-sales service.
13/12/2019 10:09:25
13/12/2019 10:09:25
Advertisement
Table of Contents
