AJAX ReX 2 User Manual page 18

Wings Signal Strength Test
Signal Attenuation Test
Temporary Deactivation
User Manual
Unpair Device
Switches ReX 2 to the Wings signal strength
test mode.
The test checks the signal strength between the
hub and ReX 2 through the photo transmission
channel and determines the optimal installation
location.
Learn more
Switches ReX 2 to the signal attenuation test
mode.
The test decreases or increases the radio
transmitter power to simulate a change in the
environment to check the stability of the
communication between the range extender
and the hub.
Learn more
Allows the hub administrator to disable the
device without removing it from the system.
Two options are available:
Entirely — the device will not execute
system commands or participate in
automation scenarios, and the system will
ignore device alarms and other noti cations.
Lid only — the system will ignore
noti cations about the triggering of the
device tamper button only.
Learn more
The system will only ignore the disabled
device. The devices connected via ReX 2 will
continue normal operation.
Opens ReX 2 User Manual in the Ajax app.
Unpairs ReX 2 from the hub and deletes its
settings.
If detectors have been connected to ReX 2, then
after unpairing the range extender they will try
to reconnect to the hub.