AJAX ReX 2 User Manual page 10

7. Click Add; the countdown will begin.
8. Turn on ReX 2 by holding the power button for 3 seconds.
To make sure ReX 2 is connected to the hub, the range extender must be located at the
same secured facility as the system (within the range of the hub's radio network).
After connecting to the hub, the logo will change its colour from red to white
within 30 seconds. The connected range extender will appear in the list of hub
devices in the Ajax app. The updating rate of the range extender states depends
on the Jeweller settings (or Jeweller/Fibra for the Ajax hybrid hubs); the default
value is 36 seconds.
If the connection fails, turn off ReX 2 and try again after 5 seconds. Suppose the
maximum number of devices has been added to the hub (depending on the
model ) when attempting to add the device. In that case, you will receive a
corresponding noti cation in the Ajax app.
ReX 2 only works with one hub. When connected to a new hub, the range
extender stops sending commands to the old one. Once added to a new hub,
hub