Board Setup; Table 1. X-Nucleo-Gnss2A1 Expansion Board - Jumper 1 Default Settings - ST X-NUCLEO-GNSS2A1 User Manual

1.3

Board setup

To set up the X-NUCLEO-GNSS2A1
Step 1. Check the jumper position shown below:
I²C-SCL
I²C-SDA
VCC-VCC_IO
V14Bat
SYS_FWD
SYS_WHEELTICK
SYS_RESETn
SYS_WAKEUP
UART-RX
UART-TX
SYS_PPS
SYS_IRQ
Step 2. Connect the
Step 3. Power the
Step 4. Program the
Step 5. Reset the MCU via the
The evaluation kit is ready-to-use.
UM3020 - Rev 1
expansion board, follow the procedure below.
Table 1. X-NUCLEO-GNSS2A1 expansion board - jumper 1 default settings
Signal
X-NUCLEO-GNSS2A1 to the
STM32 Nucleo development board using the type A mini-B USB cable.
STM32 Nucleo development board using the firmware example provided.
STM32 Nucleo development board [reset] button.
Jumper
J11 Closed
J12 Closed
J14 Closed
J15 Closed
J23 1-2
J24 2-3
J25 1-2
J26 2-3
J27 2-3
J28 2-3
J29 1-2
J30 2-3
STM32 Nucleo development board.
UM3020
Board setup
Configuration
page 4/21