Hardware And Software Requirements; Figure 2. X-Nucleo-Gnss2A1 Expansion Board Connected To An Stm32 Nucleo Development Board - ST X-NUCLEO-GNSS2A1 User Manual

1.2

Hardware and software requirements

The X-NUCLEO-GNSS2A1
UNO R3 connectors, as shown in the figure below.
Figure 2. X-NUCLEO-GNSS2A1 expansion board connected to an STM32 Nucleo development board
The X-NUCLEO-GNSS2A1
testing has been performed on the
To use the STM32 Nucleo
software and hardware specifications are required:
• a PC with Microsoft Windows
• an STM32 Nucleo
• a type A to mini-B USB cable to connect the
• the X-CUBE-GNSS1
• TESEO-SUITE.
The installation of the
requires:
• 128 MB of RAM;
• 40 MB of hard disk space.
UM3020 - Rev 1
must be plugged onto an
can be connected to any
NUCLEO-F401RE
development boards with the
®
10 to install the software package (X-CUBE-GNSS1);
development board (NUCLEO-L053R8
STM32 Nucleo
software package;
X-CUBE-GNSS1 and the TESEO-SUITE
Hardware and software requirements
STM32 Nucleo development board through the Arduino
STM32 Nucleo development board, even though complete
board.
X-NUCLEO-GNSS2A1 expansion board, the following
or NUCLEO-F401RE);
to the PC;
graphical user interface utility on the user PC
UM3020
page 3/21