Table of Contents
Advertisement
Access Panel Removal
The front access panels (x3) and one (x1) on the right side
(facing unit front) may be removed for ease of hooking up gas
and electrical--prior to finishing. Once complete ensure that the
access panel is reinstalled prior to any finishing.
See locations in diagram to the right.
Note: Once the finished material is installed, these access
panels are no longer accessible.
1. Identify access panel to be removed, remove corresponding
outer trim panel by lifting up and off (centre panel shown
below).
2. From inside the unit—push in tab to release the access
panel at the top.
3. Push the access towards the inside of the unit, lift up from
the bottom to release bottom tabs, when clear, lift out of unit.
4. Reverse steps to reinstall access panel.
Gas connection
tooltip
tooltip
installer's information
Aeration adjustment
Electrical
City Series CB60E-1 |
35
Advertisement
Table of Contents
