Table of Contents
Advertisement
LOWER THREADING
IMPORTANT
• If the spool or the spool cap is not installed
correctly, the thread may become tangled
around the spool pin and the machine may be
damaged.
• Three spool cap sizes are available, allowing
you to choose a spool cap that best fits the size
of spool being used. If the spool cap is too
small for the spool being used, the thread may
catch on the slit in the spool or the machine
may be damaged. When using mini king thread
spool, use the thread spool insert (mini king
thread spool).
For details on thread spool insert (mini king
thread spool), refer to "Note" on page 16.
Note
• When using the spool as shown below, use
the thread spool insert (mini king thread
spool). Make sure that the thread spool insert
is firmly inserted. After installing it, pull out
some thread, and check that the thread
unwinds without getting caught.
16
e
f
a Thread spool
insert (mini king
thread spool)
b Hole diameter 8.0
mm to 10.5 mm
(5/16 inch to 13/
32 inch)
c Spool (cross-
wound thread)
g
With your right hand, hold the thread near
the thread spool. With your left hand, hold
the end of the thread, and use both hands to
pass the thread through the thread guide.
a Thread guide
Pass the thread around the pretension disk
making sure that the thread is under the
pretension disk.
a
a Pretension disk
Make sure that the thread passes under the
pretension disk.
b Pretension disk
c Pull it in as far as possible.
Check to make sure thread is securely set between
pretension disks.
Wind the thread clockwise around the
bobbin 5-6 times.
Advertisement
Table of Contents
