Resetting The Main Pcb - Toshiba ESTIA R32 HWT-401HW-E Manual

Resetting the main PCB

Resetting the hydro DN
Procedure
1. Continue with the hydro DN settings screen.
2. Press and hold [
NOTE
• After resetting the DN, it takes a few minutes for the normal screen to be restored.
The first communication screen is displayed for a few more minutes, but this is NOT a problem.
• After resetting the DN, some of the following points must be confirmed and reset.
DN
11 Capacity of the water-to-air heat exchanger
6B8 Hot water supply used
6BA ZONE2 operation used
6BC Capacity of the backup heater
Resetting the remote control DN
Procedure
1. Continue with the remote control DN settings screen.
2. Press and hold [
30 I TOSHIBA 30 I
TOSHIBA
[ ] in the DN settings screen and select "YES".
] [ ]
Subject
[ ] in the DN settings screen and select "YES".
] [ ]
Details
0010: 601 0015: 1101
0000: Yes 0001: No
0000: No 0001: Yes
0000: 3 kW 0001: 6 kW
0002: 9 kW
Preset
Dependent on type
0000: Yes
0000: No
Dependent on type