Ortech DISC-RG2 Instruction Manual

LED Slim Lights
MODEL DISC-RG2
For your safety, this fixture MUST be wired in accordance to electrical codes and ordinances
CAUTION
PLEASE READ INSTRUCTION BEFORE COMMENCING INSTALLATION AND RETAIN FOR FUTURE REFERENCES.
Electrical products can cause death or injury, or damage to property.
If in any doubt about the installation or use of this product, consult a competent electrician.
INSTALLATION GUIDE
Tools Required
• Saw
• Measuring Tape
• Electrical Wiring (use type and gauge suitable for
application to connect the fixtures)
Driver Wiring
1. Open the hardwire box swing cover and remove the appropriate knockout(s)
2. Insert the electrical supply cable through the knockout and secure with a
cable connector (sold separately)
3. Using wire nuts, connect GREEN ground wire of cable to GREEN wire on box.
Connect WHITE wire of cable to WHITE wire of box. Connect BLACK wire of
cable to BLACK wire of box (see Fig.1 on the right)
4. Place all wiring and connections back into the box and close the cover
5. Insert hardwire box through the mounting hole (see Fig.2 on the right).
New Construction Applications:
Hardwire box shall be firmly secured after the mounting plates, studs, joists,
or structural units have been concealed.
Remodel Applications:
DO NOT require the hardwire box to be firmly secured after the mounting
plates, studs, joists, or structural units have been concealed.
info@ortechindustries.com
www.ortechindustries.com
WARNING
WARNING — THE INSTALLATION MUST BE CARRIED OUT BY
A QUALIFIED ELECTRICIAN.
1. LED Slim Lights are suitable for indoor use only. DO NOT use outdoors
2. Please keep the LED Slim Lights away from any corrosive substance, and please use dry cloth
when you clean them
3. LED Slim Lights can only be installed by a qualified electrician
4. Before installation or maintenance, please disconnect the power to prevent electric shock
Application Notice
Pre-installation
1. Turn power OFF from the electrical panel before starting installation
2. Locate a suitable position to plate the fixture and open in
3. Run electrical wire from the switch (power supply) through the
13376 Comber Way
Surrey BC V3W 5V9
accordance to the cut-hole dimensions (refer to HOLE CUT SIZE
TABLE below for appropriate size)
mounting hole — use NMD90 Romex or BX cable
Fig.1
Fig.2
375 Admiral Blvd
Mississauga ,
ON L5T 2N1
Instruction Manual
White
wire
To
fixture
1-888-543-6473
1-888-541-6474