Sub-Zero Classic Series Installation Manual page 11

Installation
Completion
KICKPLATE INSTALLATION
Reinstall the drain pan and verify it is in the proper position.
Install the kickplate using the magnets to attach it to the
brackets on the inside of each roller base. Refer to the
illustration below. The kickplate must be removable for
service. The floor cannot interfere with removal. Refer
to the label mounted on the kickplate support for height
clearance.
To turn power on to the unit, touch and hold on the
control panel.
Kickplate installation
Sub-Zero, Sub-Zero & Design, Sub-Zero & Snowflake Design, Dual Refrigeration, The Living Kitchen, Great American Kitchens The Fine Art of Kitchen Design, Wolf, Wolf & Design, Wolf Gourmet, W & Design, red colored knobs, Cove, and Cove & Design are registered trademarks and service marks of Sub-Zero Group, Inc. and its subsidiaries.
All other trademarks are property of their respective owners in the United States and other countries.
WATER FILTER BYPASS
If the water filtration system will not be used, it can be
placed in water filter bypass mode by removing the water
filter. Refer to the illustration below. Follow these steps to
remove the water filter:
Pull out on the bottom edge of the grille assembly and
1
tilt the grille frame upward.
2 To remove the cartridge, rotate the cartridge counter-
clockwise one-quarter turn and pull out. Refer to the
illustration below.
WATER FILTER
WATER
FILTER
Water filter location Water filter removal
90° DOOR STOP
The doors of all models open to 110°. A 90° door stop is
provided with the unit (located behind the grille). Additional
90° door stop kits are available through an authorized
Sub-Zero dealer.
WARNING
Follow all city and state laws when storing, recycling,
or discarding unused refrigerators and freezers.
subzero.com | 11