Completion - Sub-Zero Classic Series Installation Manual

Installation
Alignment
DOOR ADJUSTMENT
Side-by-side and over-and-under doors are adjustable in
and out, and side to side tilt. Side-by-side doors only are
adjustable up and down and the handle sides are adjust-
able in and out. To adjust the handle side, rotate the
adjustable door bumper. Refer to the illustration below.
ADJUSTABLE
DOOR BUMPER
Adjustable door bumper
10 | English
To make all other adjustments, loosen the two upper hinge
bolts using a 1/2" wrench. Refer to the illustration below.
In-and-Out Adjustment: For left-hinge doors, use a 5/32"
allen wrench to turn the adjustment bolt clockwise to
adjust the handle side inward, and counterclockwise to
adjust outward. Reverse directions for a right-hinge door.
Side-to-Side Tilt Adjustment: For left-hinge doors, use a
3/8" wrench to turn the adjustment bolt clockwise to adjust
the handle side upward, and counterclockwise to adjust
downward. Reverse directions for a right-hinge door.
Up-and-Down Adjustment: For left-hinge doors, use a 1/4"
allen wrench to turn the adjustment bolt clockwise to raise
the door and counterclockwise to lower. Reverse directions
for a right-hinge door. Refer to the illustration below.
UPPER
HINGE BOLTS
IN-AND-OUT
ADJUSTMENT
SIDE-TO-SIDE
TILT ADJUSTMENT
Door adjustment bolts Up-and-down door adjustment

Completion

GRILLE INSTALLATION
Install the grille assembly and check for proper fit. The
grille is designed to rest on the upper door hinge(s) to min-
imize the reveal between the top of the door and bottom
of the grille. To eliminate interference, the grille height can
be adjusted. Loosen the four grille adjustment screws (two
on each side) and adjust the grille height as needed. Refer
to the illustration below.
BACK GRILLE
SCREW
GRILLE
ADJUSTMENT
SCREWS
FRONT
GRILLE SCREW
Grille height adjustment
ANCHORING
After the unit has been leveled and door adjustment com-
pleted, anchor the unit to the opening to ensure a proper
fit and secure installation.
To anchor the top of the unit, open the grille and install the
screws provided through the grille frame into cabinetry.
There are several hole locations. Refer to the illustration
below. Check for proper door clearance by opening the
door.
To anchor the bottom of the unit, drive a screw through
the side hole inside each roller base assembly. The screw
will need to go in at an angle to attach properly. Refer to
the illustration below. Additional material may be needed
behind the cleat to ensure sufficient anchoring.
CAUTION
If the screws provided are not suitable for the instal-
lation, use adequate screws.
WARNING
To avoid a hazard due to instability of the appliance,
it must be fixed in accordance with the instructions.
VERANKERINGS-
BOUTEN
ANCHORING
SCREW
Top anchoring Bottom anchoring