Volvo Guard Alarm II Programing Manual

© Copyright 2004 Volvo Car Corporation. All rights reserved.
Programing Guard Alarm II key code
Programing key code manually
Programing key code with programing box
"VCC-032946 EN 2012-08-06"
All remote controls to be used with the alarm
system must be programed at the same time
(up to 4 remote controls).
Programing key codes can also be done using
the programing box as per the next
page.Programing key code with programing
box .
The programing procedure is as follows:
- Shut all doors, hood (bonnet) and trunk
(boot).
- Switch ignition on and off at least 5 times in
10 seconds.
Indicator LED should start to flash. Leave
ignition on.
Once the indicator LED starts flashing, the first
remote control must be programed within 15
seconds.
- Press one of the buttons on one of the
remote controls.
The programing is acknowledged by the
indicator LED lighting up and staying on for
approx. 2 seconds.
The indicator LED then starts flashing for 10
seconds.
- Program the other remote control within 10
seconds, i.e. while the indicator LED is
flashing.
- Ignition off.
- Test remote controls.
"Read new KeyCode" button
- Press button A "Read new KeyCode".
Display reads, "READ NEW KEYCODE" ,
(PRESS KEY.)
1(2)