Page 5
Certain steps in the instructions are only presented in the form of images. Explanatory text is also given for more complicated steps. In the event of any problems with the instructions or the accessory, contact your local Volvo dealer. Preparations Preparations Open boot lid.
Page 7
Installation instructions, accessories Volvo Car Corporation Gothenburg, Sweden Take hold of the bumper shell end and carefully pull outward until the six catches release. Repeat on the other side. IMG-226341 Note! It is easier if two people work to remove the bumper.
Page 9
Installation instructions, accessories Volvo Car Corporation Gothenburg, Sweden Installation Clean any underseal and dirt from the inner member of the bumper where the L-profile for the towbar is to be located. Clean the metal flange on the inside and outside where the reinforcement stay is to be located.
Page 10
Installation instructions, accessories Volvo Car Corporation Gothenburg, Sweden Fit the towbar retainer on the L profile using two M14x110 flanged screws and corresponding flanged nuts. Do not tighten yet. IMG-241886 Illustration A Applies to vehicles with 5-cylinder engine Place a support under the muffler.
Page 11
Installation instructions, accessories Volvo Car Corporation Gothenburg, Sweden Applies to vehicles with 5-cylinder engine Remove the screws and brackets of the muffler mount on the right and left side. IMG-242363 Applies to vehicles with 4-cylinder engine Detach the rubber mounting for the end pipes from the bracket on the underneath of the left side member.
Page 12
Installation instructions, accessories Volvo Car Corporation Gothenburg, Sweden Prise in the reinforcement stay from the back over the muffler. IMG-271069 Install three M8x30 screws with washers on each side of the reinforcement stay. Do not tighten yet. Install in the order illustrated.
Page 14
Installation instructions, accessories Volvo Car Corporation Gothenburg, Sweden Tighten the L profile's four M10 screws (1) alternatingly so that the L profile and the inner member of the bumper lie against each other correctly. Tightening torque: 47 Nm (35 lbf.ft).
Page 15
Installation instructions, accessories Volvo Car Corporation Gothenburg, Sweden Illustration A: Applies to all Refit the rubber mounting. Remove the support from under the muffler. Install the towbar wiring following separate installation instructions. Illustrations B & C: Apply to vehicles with engine D5204T/T5...
Page 16
Installation instructions, accessories Volvo Car Corporation Gothenburg, Sweden Applies to all models Make the cut-out in the bumper shell following the existing marking. Even off the edges using a fine-toothed file. IMG-225762 Connect any parking assistance connectors and reinstall the bumper.
Page 17
Installation instructions, accessories Volvo Car Corporation Gothenburg, Sweden Storing the towbar Applies to vehicles without spare wheel Put the towbar in the protective pouch and position them as illustrated. Fasten the towbar and protective pouch with the strap that is pulled through the luggage retainer hook.
Installation instructions, accessories Volvo Car Corporation Gothenburg, Sweden Affix the foam tape. IMG-225811 Put the towbar in the protective pouch and position them as illustrated. Fasten the towbar and protective pouch with the strap that is pulled through the slots in the rim.
Page 19
Volvo Car Corporation Gothenburg, Sweden Finishing work Fasten the accompanying label on the load hatch. Fill in the registration card and send it to the local Volvo dealer. IMG-241905 Take the cradle for the protective cover from the kit and press into the hole for the towbar.
Page 20
Installation instructions, accessories Volvo Car Corporation Gothenburg, Sweden Press the protective cover into the cradle until it lies against the bumper cover. A number of clicks should be heard when the protective cover is pressed into place. Check that the protective cover lies against the bumper cover Check that the protective casing is fitted securely.