Installation; General Information; Location Of The 9060 - Ransburg 9060 Service Manual

INSTALLATION

GENERAL INFORMATION

The following section contains general information on
the installation of 9060 High Voltage Controller.
W A R N I N G
!
† The 9060 Controller MUST be located
outside of the hazardous area.
† The User MUST read and be familiar with
the "Safety" section of this manual.
† This manual MUST be read and thoroughly
understood by ALL personnel who operate,
clean, or maintain this equipment! Special care
should be taken to ensure that the warnings and
requirements of operating and servicing safely
are followed. The user should be aware of and
adhere to ALL local building and fire codes and
ordinances as well as NFPA-33, OSHA, and all
related country safety codes prior to installing,
operating, and/or servicing this equipment.
† Only approved applicators should be used
with the 9060 High Voltage Controller.
† As each installation is unique, this information
is intended to provide general installation
information for the 9060 Controller. Consult
your authorized Ransburg distributor for specific
directions pertaining to the installation of your
equipment.
CP-17-02
9060 Classic High Voltage Controller -
NOTE
Return To Contents

LOCATION OF THE 9060

Install the controller in an area outside the hazardous
location in accordance with federal, state, and local
codes. The area should protect the controller from
the possibility of environmental intrusion (such as
dust or moisture), have ambient temperatures that do
not exceed 40°C, and be as close to the applicator as
possible to minimize the length of the high voltage cable.
CAUTION
!
† DO NOT locate the Controller near or adjacent
to heat producing equipment such as ovens, high
wattage lamps, etc.
The controller may be free standing on any flat surface
or wall mounted (wall mount brackets not supplied) as
shown in Figure 5.
FRONT VIEW
SIDE VIEW
Figure 5: Typical Controller Mounting
INSTALLATION
12