Advertisement
Quick Links
Corning
®
Demonstration Equipment
Instructions
These instructions are to help guide you through unpacking the Corning
Matribot bioprinter at the beginning of your demo and through repacking the
Corning Matribot bioprinter at the end of your demo. If you have any questions,
please contact your Corning representative.
Matribot
®
Bioprinter
Advertisement
Related Manuals for CORNING Matribot Bioprinter
Summary of Contents for CORNING Matribot Bioprinter
- Page 1 These instructions are to help guide you through unpacking the Corning Matribot bioprinter at the beginning of your demo and through repacking the Corning Matribot bioprinter at the end of your demo. If you have any questions, please contact your Corning representative.
- Page 2 Always use a minimum of two people to unpack and move the Corning Matribot Bioprinter. The Corning Matribot Bioprinter should never be placed on wet, damp, moist, or humid surfaces. Do not force or tear anything during the unpacking or setup process as this may irreversibly damage your Corning Matribot Bioprinter.
- Page 3 6. Remove the top protective shipping foam. 7. Use the Corning Matribot bioprinter frame to grab the device. Be careful not to grab any movable parts or loose components. It is recommended to have 2 people lift from the sides of the frame at the indicated locations.
- Page 4 12. Take the surface probe out of the electrical supply box and place it inside the device. 13. Refer to the Corning Matribot Bioprinter Instruction Manual (CLS-AN-641DOC) or the Corning Matribot Bioprinter Introduction videos for start up instructions and support.
- Page 5 Repacking the Corning Matribot Bioprinter 1. Unplug the power supply and outlet cord as well as the USB cable from the Corning Matribot bioprinter. Remove any attached thermal insulators from the cooling block, detach the surface probe from its storage magnet, and eject the SD card if in use.
- Page 6 Insert the top inner foam insert from the top of the unit as shown. 7. Place the Corning® Matribot® bioprinter inside the plastic bag, ensuring that the bioprinter is completely covered.
- Page 7 NOTE: The bottom shipping foam has a cutout for the LCD knob on the Corning® Matribot® bioprinter (see red arrow). 9. Use the Corning Matribot bioprinter frame to grab the device. Be careful not to grab any movable parts or loose components. It is recommended to have 2 people lift from the sides of the frame at the indicated location.
- Page 8 After your demo of the Corning Matribot® bioprinter is complete, please uninstall/remove Corning DNA Studio software from your computer following the instructions below. • If you are using a Windows operating system, locate Corning DNA Studio in the Apps and Features settings or in the Control Panel Programs and Features. Select uninstall.
Need help?
Do you have a question about the Matribot Bioprinter and is the answer not in the manual?
Questions and answers