Optional I/O Modules (Vga/Hdmi/Dp); Removing Optional I/O Module - Dell OptiPlex 3000 Small Form Factor Service Manual

Steps
1. Insert the PS2 module into its slot on the chassis.
2. Connect the PS2-module cable to the connector on the system board.
3. Close the expansion-card door, and press until it clicks into place.
Next steps
1. Install the heat-sink and fan
2. Install the side cover.
3. Follow the procedure in

Optional I/O modules (VGA/HDMI/DP)

Removing optional I/O module

Prerequisites
1. Follow the procedure in
2. Remove the side cover.
3. Remove the front bezel.
4. Remove the heat-sink and fan
About this task
The following images indicate the location of the optional I/O module and provides a visual representation of the removal
procedure.
NOTE: The removal procedure for the VGA/DP/HDMI optional I/O modules are the same.
Steps
1. Remove the two screws that secure the I/O module to the chassis.
64 Removing and installing components
assembly.
after working inside your
before working inside your
assembly.
computer.
computer.