Table of Contents
Advertisement
About this task
The following images indicates the location of the M.2 2280 PCIe solid-state drive and provide a visual representation of the
installation procedure.
Steps
1. Align the notch on the 2280 solid-state drive with the tab on the M.2 card slot on the system board.
2. Slide the 2280 solid-state drive into the M.2 card slot on the system board.
3. Replace the screw (M2x3) that secures the 2280 solid-state drive to the system board.
Next steps
1. Install the
hard-drive and optical-drive
2. Install the
3.5-inch
hard-drive.
3. Install the
2.5-inch
hard-drive.
4. Install the
front
bezel.
5. Install the
side
cover.
6. Follow the procedure in
Bay-support bracket
Removing the bay-support bracket
Prerequisites
1. Follow the procedure in
2. Remove the
side
cover.
38
Removing and installing components
bracket.
after working inside your
before working inside your
computer.
computer.
Advertisement
Table of Contents
Need help?
Do you have a question about the OptiPlex 3000 Small Form Factor and is the answer not in the manual?
Questions and answers