Installing The Bay-Support Bracket - Dell OptiPlex 3000 Small Form Factor Service Manual

3. Remove the front bezel.
4. Remove the 2.5-inch
5. Remove the 3.5-inch
6. Remove the disk-drive
About this task
The following images indicate the location of the bay-support bracket and provide a visual representation of the removal
procedure.
Steps
1. Remove the two (#6-32) screws that secures the bay-support bracket to the chassis.
2. Push the bay-support bracket to free it from the front side of the chassis.
3. Lift and remove the bay-support bracket from the system.

Installing the bay-support bracket

Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the bay-support bracket and provides a visual representation of the installation
procedure.
hard-drive.
hard-drive.
cage.
Removing and installing components 39