Table of Contents
Advertisement
Steps
1. Align the graphics card with the PCIe x16 card slot on the system board.
2. Using the alignment post on the PCIe slot, connect the card in the connector and press down firmly. Ensure that the card is
firmly seated.
3. Close the PCIe door.
Next steps
1. Install the
side
cover.
2. Follow the procedure in
Removing the Dell Ultra Speed Drive Gen 4 card
Prerequisites
1. Follow the procedure in
2. Remove the
side
cover.
after working inside your
before working inside your
computer.
computer.
Removing and installing components
59
Advertisement
Table of Contents
Need help?
Do you have a question about the OptiPlex 3000 Small Form Factor and is the answer not in the manual?
Questions and answers