Installing The Intrusion Switch; Optional I/O Modules (Type C/ Hdmi/Vga/Dp/Serial); Removing Optional I/O Modules (Type C/ Hdmi/Vga/Dp/Serial) - Dell OptiPlex 3080 Small Form Factor Service Manual
Hide thumbs
Also See for OptiPlex 3080 Small Form Factor:
- User manual (8 pages) ,
- Setup and specifications (39 pages) ,
- Service manual (66 pages)
Table of Contents
Advertisement
Installing the intrusion switch
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the intrusion switch and provides a visual representation of the installation
procedure.
Steps
1. Insert the intrusion switch into its slot and slide the switch to secure it into the slot.
2. Connect the intruder cable to the connector on the system board.
Next steps
1. Install the fan duct.
2. Install the side cover.
3. Follow the procedure in after working inside your computer.
Optional I/O modules (Type C/ HDMI/VGA/DP/Serial)
Removing optional I/O modules (Type C/ HDMI/VGA/DP/Serial)
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the side cover.
3. Remove the front bezel.
4. Remove the chassis fan.
5. Remove the fan duct.
62
Field service information
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the OptiPlex 3080 Small Form Factor and is the answer not in the manual?
Questions and answers