JUKI PS-800SB-2850 Instruction Manual page 55

Error
Error description
Code
E113 Broken spindle encoder
E114 Spindle encoder AB inter-
ference
E115 Spindle encoder Z interfer-
ence
E116 Spindle multi turn data out
of range
E117 Spindle absolute encoder
overheating
E118 Spindle battery voltage is
too low
E119 Spindle multi turn position
is missing
E120 Spindle motor overload
E121 Overload of spindle drive
E122 Spindle braking resistor
overload
E123 Overheated spindle motor
E124 Overheated spindle drive
E125 Undervoltage of spindle
bus
E126 Spindle busbar overpres-
sure
E127 Spindle main power off
E128 Spindle software overcur-
rent
E129 Spindle position forward
limit
E130 Negative limit of spindle
position
E131 Spindle electronic gear
ratio error
E132 Spindle input pulse fre-
quency is too high
E133 Excessive spindle position
deviation
Fault Cause
1. Poor contact or broken wire of
the spindle encoder
2. The spindle motor is damaged
1. The power board program is the
old version
2. Poor contact or broken wire of
the spindle encoder
1. The spindle board program is the
old version
2. Mechanical stuck
– 52 –
Solution
1. Check the spindle encoder line
2. Replace the spindle motor
1. Look at the screen "Internal Drive" -
"Version Number", 1 means the old
version needs to be returned to the
factory to update the program
2. Check the encoder cable
Refer to E114 Error Handling Method
Refer to E092 Error Handling Method
E090
Refer to Error Handling Method
Refer to E091 Error Handling Method
Spare alarm
Refer to E026 Error Handling Method
Refer to E026 Error Handling Method
Refer to E089 Error Handling Method
Refer to E415 Error Handling Method
Refer to E416 Error Handling Method
Refer to E410 Error Handling Method
Spare alarm
Spare alarm
E412
Refer to Error Handling Method
Spare alarm
Spare alarm
Spare alarm
Spare alarm
1. "Internal drive" - "spindle" no version
number means that the old version
needs to be returned to the factory to
update the program
2. Check the machinery