JUKI PS-800SB-2850 Instruction Manual page 46

Classifi-
cation of No. Parameter name
parameters
Reset P39 Return-to-origin speed
setting (mm/min)
P756- Output I/O setting before
P761 resetting
P762-
P797
P649 Alarm in the case of a
resetting error
P782- Output IO setting after
resetting
P787
P788-
P793
Tempo- P40 Automatic thread trimming
during the temporary stop
rary stop
setting
P41 Needle position during the
temporary stop
P45 Type of the temporary stop
switch
P799 The presser foot does not
go up during the temporary
stop
Statistics P49 Bobbin thread remaining
amount is cleared at the
settings
time of turning the power
ON
P50 Operation stops after the
bobbin thread has run out
P51 Bobbin thread counter
setting is enabled
P46 Bobbin thread counter is
cleared at the time of turn-
ing the power ON
P47 Operation continues after
the counter has reached
the set value
P48 Counter setting is enabled
P52 Working hours counter
P779 Bobbin thread count mode
P780 Adjustment value of the
surplus amount of bobbin
thread (mm)
Standard
Range
value
100 to 60000 15000
OUT1 to OUT6 Not set
/ Not set
High level / Low High level
level
Yes/No No
OUT1 to OUT6 Not set
/ Not set
High level / Low Low level
level
Yes/No No
Upper stop Upper
position / Lower stop posi-
stop position tion
Self lock / Nor- Self lock
mal
Yes/No No
Yes/No No
Yes/No No
Yes/No No
Yes/No No
Yes/No No
Yes/No No
Yes/No No
IN1 to IN4 / Default
default
0 to 600000 0
– 43 –
Meaning of parameter and comment
X, Y axes speed during resetting to the
origin
Setting of IO before resetting
Setting of IO after returning to the origin
"Yes" : Thread is automatically trimmed
"No" : Thread is not trimmed
In the case the temporary stop switch
type is "Self lock", the temporary stop
function does not automatically oper-
ate when the switch is pressed.
In the case the temporary stop switch
type is "Normal", the temporary stop
function automatically operates when
the switch is pressed.
Whether the remaining amount of
bobbin thread is reset to 0 (zero) when
turning the power ON
In the case of "Yes", the sewing ma-
chine stops when the consumed bobbin
thread length has reached the "entire
length".
In the case of "Yes", statistics automat-
ically indicate the consumed bobbin
thread length
Whether the sewing counter is reset to
0 (zero) when turning the power ON
Whether the operation is continued
after the sewing counter has reached
the set value
Whether the sewing counter is enabled
In the case of "Yes", the machining time
statistics function is enabled
Statics mode of the bobbin thread
amount
Adjustment of the bobbin thread re-
maining amount