Advertisement
2.
INSTALLING THE MOUNT
i. Determine the centre of the rst screen at the bottom left. Mark the centre, for the centre of the rail.
WALL
ii. Mark and drill two xing holes for each item A1 assembled.
Insert item A3 and the top item A2. Do not fully tighten -
Allow a gap (approx.10mm).
iii. Hook item A1 on to item A2 using the keyholes.
Once the rail is hooked on, fasten item A2 into the
bottom holes and tighten all xings.
iv. Fit item B2 to the ends of item B1.
Centre of
screen
marked
on wall
Centre of rail
Centre lines aligned
when xed to wall
10mm
A2
B2
ii.
A1
B1
10
A3
A2
WALL
10mm Masonry bit
LEVEL
Advertisement
