Table of Contents
Advertisement
2. PRINTER SETUP
2.7 Loading the Media
(Cont.)
CAUTION!
To separate the printed
media from the media roll in
batch mode, be sure to tear
off the media at the Media
Outlet or cut the media past
the Strip Plate. If you tear
off the media at the Print
Head by mistake, be sure to
feed one label (10 mm or
more) with the FEED Button
prior to a next issue. Failure
to do this may cause a paper
jam
ATTENTION!
Lorsque vous déchirez la
bande de papier imprimé,
assurez-vous de la déchirer
contre le bord plastique de la
sortie papier, ou bien au delà
de la barre de pré décollage.
Si par erreur vous déchirez
le papier sur l'arête de la tête
d'impression, il faut avancer
le media d'une étiquette (10
mm ou davantage) à l'aide
de la touche FEED/PAUSE
avant d'effectuer
l'impression suivante, faute
de quoi vous pourriez avoir
un bourrage papier..
Close the Top Cover gently and push down the arrow-indicating
9.
portions until they click.
10. Press the [FEED] button to check for a proper media feed.
There are two issue modes available for this printer.
Batch mode:
In the batch mode, the media is continuously printed and fed until the
number of media specified in the issue command has been printed.
Linerless Cut mode (Option):
How to install the Linerless Cutter
Please refer to the Installation Manual of the Linerless cutter.
E2-10
ENGLISH VERSION EO1-33095
2.7 Loading the Media
FEED Button
Advertisement
Table of Contents
