Table of Contents
Advertisement
2. PRINTER SETUP
2.7 Loading the Media
(Cont.)
NOTES:
1. The sensor type used in the last
print job has been selected. To
change the sensor type, refer to
Section 2.8.1 Media Sensor
Calibration.
2. The Feed Gap Sensor is
positioned 6.35 mm right from
the media centre.
Feed Gap Sensor
6.35mm
NOTE:
Be careful the Media Guides do
not squeeze the media. Doing
so bends the media, causing a
paper jam or feed failure.
6. Adjust the media sensor position and select a sensor type to be used. .
(Refer to Section 2.8.1)
This printer is provided with a Feed Gap Sensor which detects inter-label
gaps.
As the Feed Gap Sensor position is fixed, it is not necessary to move it.
7. Pass the media between the Media Guides, and turn the Media Guide
Adjustment Dial in the arrow indicating direction to adjust the Media
Guides to the media width.
8. Push the Media Holders against the media roll to firmly hold it, and
then slide the Media Holder Lock Switch to the Lock (▼) side.
E2- 9
ENGLISH VERSION EO1-33095
2.7 Loading the Media
Advertisement
Table of Contents
