Toro After Groundsmaster 4500-D Operator's Manual page 9

3. Remove the paper backing from the
double-faced tape on both sides of the cab unit
(Figure 15).
1. Double-faced tape
4. Apply the left tank foam to the cab unit
15).
5. Apply the right tank foam to the cab unit.
Applying the Rear Foam Seals
1. Remove the paper backing from the
double-faced tape at the back of the cab unit
(Figure 16).
1. Left, rear foam seal
2. Double-faced tape
2. Apply the left, rear and right, rear foam seals to
the cab unit (Figure
3. Apply the rear foam seal to the back of the cab
unit (Figure 17).
Figure 15
2. Left tank foam
Figure 16
3. Right, rear foam seal
16).
1. Rear foam seal
g030703 4
Installing the Cab Mounts
(Figure
Parts needed for this procedure:
1 Left, front mount
1 Right, front mount
7
Bolt (3/8 x 1 inch)
5 Flange nut (3/8 inch)
2 Locknut (3/8 inch)
1 Left, rear mount
1 Right, rear mount
Installing the Left Front Mount
1. Remove the existing hardware and use the 3
bolts (3/8 x 1 inch) and flange nuts to secure the
mount to the machine
g034905
9
Figure 17
2. Application area
(Figure 18).
g030708