Toro After Groundsmaster 4500-D Operator's Manual page 24

Cleaning the Cab Air Filters
Service Interval: Every 250 hours
1. Remove the screws and grates from both the
in-cab and rear cab air filters
Figure 60).
Figure 59
In-Cab Air Filter
1. Filter
2. Grate
Figure 60
Rear Cab Air Filter
1. Filter
2. Grate
2. Clean the filters by blowing clean, oil-free,
compressed air through them.
(Figure 59 and
g030417
3. Screw
g028379
3. Screw
Important:
If either filter has a hole, tear, or
other damage, replace the filter.
3. Install the filters and the grate with the
thumbscrews.
Cleaning the Cab Pre-Filter
The purpose of the cab pre-filter is to prevent large
debris, such as grass and leaves from entering the
cab filters.
1. Rotate the screen cover down.
2. Clean the filter with water.
Note:
Do not use a pressure washer.
Important:
If the filter has a hole, tear, or
other damage, replace the filter.
3. Allow the pre-filter to dry before installing it into
the machine.
4. Rotate the filter screen around the tabs until
the latch locks into the latch-mount assembly
(Figure 61).
1. Latch-mount assembly
2. Latch
24
Figure 61
3. Screen cover
g032951