Toro After Groundsmaster 4500-D Operator's Manual page 8

Figure 12
1. Rubber isolator
Note:
Use soapy water and a mallet to assist with
inserting the rubber isolator into the hole.
3
Applying the Foam Seals
Parts needed for this procedure:
1 Left, front foam seal
1 Center, front foam seal
1 Right, front foam seal
1 Left foam seal
1 Right foam seal
1 Left tank foam
1 Right tank foam
1 Left, rear foam seal
1 Right, rear foam seal
1 Rear foam seal
Applying the Front Foam Seals
Apply the center, front foam seal and then the left,
front and right, front foam seals approximately 3 mm
(1/8 inch) from the edge on the front of the cab unit
(Figure 13).
g030686
2. Right, rear mount
1. Application area
2. Left, front foam seal
Note:
Install the ends of the foam seals to interlock
and create a solid seal.
Applying the Side Foam Seals
1. Apply the left foam seal approximately 3 mm
(1/8 inch) from the edge on the front, left section
of the cab unit
Note:
Install the ends of the foam seals to
interlock and create a solid seal.
1. Application area
2. Apply the right foam seal approximately 3 mm
(1/8 inch) from the edge on the right, front
section of the cab unit.
Note:
Install the ends of the foam seals to
interlock and create a solid seal.
8
Figure 13
3. Center, front foam seal
4. Right, front foam seal
(Figure 14).
Figure 14
2. Left foam seal
g030692
g030702