Toro After Groundsmaster 4500-D Operator's Manual page 7

2
Preparing the Cab Mounts
Parts needed for this procedure:
1 Left, front mount
1 Right, front mount
1 Left, rear mount
1 Right, rear mount
4 Rubber isolator
Preparing the Front Mount
Press a rubber isolator into each hole in the front
mounts (Figure 9).
1. Rubber isolators
2. Left, front mount
Note:
Use soapy water and a mallet to assist with
inserting the rubber isolators into the holes.
Figure 9
3. Right, front mount
Drilling the Front Mount Holes
Follow this procedure only if necessary.
Locate and drill 2 holes (13/32 inch diameter) for the
right, front mount as shown in
1. Hole (13/32 inch diameter) 4. 21 mm (0.83 inch)
2. 52 mm (2.07 inches)
3. 17 mm (0.67 inch)
Preparing the Rear Mounts
1. Press a rubber isolator into the hole of the left,
rear mount on the cab frame
g030678
1. Rubber isolator
2. Press a rubber isolator into the hole of the right,
rear mount on the cab frame
7
Figure 10.
Figure 10
5. 23 mm (0.89 inch)
(Figure 11).
Figure 11
2. Left, rear mount
(Figure 12).
g030684
g030685