CTA ADD-ADMA Instruction Manual

Articulating Desk Mount Arm with VESA Plate
CONTENTS:

INSTRUCTIONS:

1

BASE MOUNT INSTALLATION

D
E
Find the included base
pad (E) and peel off the
backing. Align to the
underneath of the
C-Clamp (D) and apply
While the clamp is in unlocked mode, rotate the
pad.
knob at the bottom (as shown above) to loosen
or securely tighten to the table top.
3

BASE CLAMP SECURITY SETUP

C
2A. When the C-Clamp is securely
attached to a surface, use the
provided security tool (C), attach to
security component, and rotate
closewise to put the C-Clamp in an
'locked' state. To loosen, rotate
counterclockwise with the security
tool.
ADD-ADMA
A
B
C
ALIGNING SECURITY TOOL WITH SECURITY COMPONENT
C
2B. Align the (2) dimples on the underneath of the
security tool into the two holes on the security
component on the clamp as shown above
D
ARM & BASE CLAMP
2

ADJUSTMENTS

B
If you need to remove the arm
from the base clamp, take the
provided tool (B), rotate, and
loosen connection.
2C. Rotate counter-clockwise to
loosen and place the clamp in an
'unlocked' state. Continue rotating
until there is enough slack to rotate
the knob.Turn it clockwise to tighten
and place the clamp in a 'locked'
state.
E
F
2
D
Remove arm (D) from the
base clamp mount. Repeat
steps in reverse order to
re-install connection