Table of Contents
Advertisement
Configuring the Interfaces
Table 4-3
Examples of the show interfaces pos Command for the Supported Platforms (continued)
PLatform
VIP in the Cisco 7500 series
routers (7505, 7507, 7513)
Cisco 7600 series routers (7603,
7606, 7609, 7613) with
FlexWAN or Enhanced
FlexWAN
1. For the Cisco 7206VXR router shelves in the Cisco AS5800, the interface specified in the above example would include a shelf number. For example,
the command show interface 5/3/0 specifies the OC-3 interface of the PA-POS-1OC3 in port adapter slot 3 of router shelf 5.
Re-enable interfaces by doing the following:
Step 5
a.
b.
c.
Performing a Basic Configuration
Following are instructions for performing a basic configuration, which include enabling an interface
(with the no shutdown command) and specifying IP routing. You might also need to enter other
configuration commands, depending on the requirements for your system configuration and the
protocols you plan to route on the interface.
For complete descriptions of configuration commands and the configuration options available for the
interfaces of your port adapter, refer to the appropriate software documentation.
In the following procedure, press the Return key after each step unless otherwise noted. At any time,
you can exit the privileged level and return to the user level by entering disable at the prompt as follows:
Router# disable
Router>
PA-POS-1OC3 Single-Port Port Adapter Installation and Configuration Guide
4-6
Command
show interfaces pos followed by
slot/port-adapter/port
(interface-processor-slot-number/
port-adapter-slot-number/
interface-port-number)
show interfaces pos followed by
slot/port-adapter/port
(module-slot-number/
port-adapter-bay-number/
interface-port-number)
Repeat
Step 3
to re-enable an interface. Substitute the no shutdown command for the shutdown
command.
Repeat
Step 4
to write the new configuration to memory. Use the copy running-config
startup-config command.
Repeat to verify that the interfaces are in the correct state. Use the show interfaces command
followed by the interface type and interface address of the interface.
Chapter 4
Configuring the PA-POS-1OC3
Example
The example is for interface 0 in port adapter
slot 1 of a VIP installed in interface processor
slot 1.
Router#show interface pos 1/1/0
Pos 1/1/0 is administratively down, line
protocol is down
[Additional display text omitted from
this example]
The example is for interface 0 on a port adapter
in port adapter bay 0 of a FlexWAN module in
module slot 3.
Router# show interfaces pos 3/0/0
Pos 3/0/0 is administratively down, line
protocol is down
[Additional display text omitted from
this example]
OL-6514-04
Advertisement
Table of Contents
