Table of Contents
Advertisement
Chapter 4
Configuring the PA-POS-1OC3
Enter configuration mode and specify that the console terminal will be the source of the configuration
Step 1
subcommands as follows:
Router# configure terminal
Enter configuration commands, one per line.
Router(config)#
Specify the new interface to configure by entering the interface pos command, followed by the interface
Step 2
address of the interface you plan to configure.
Table 4-4
Table 4-4
Examples of the interface pos Subcommand for the Supported Platforms
Platform
1
Cisco 7200 VXR routers
Cisco 7201 router
Cisco 7301 router
Cisco 7304 PCI Port Adapter
Carrier Card in a Cisco 7304
router
Cisco 7401ASR router
VIPs in the Cisco 7500 series
routers (7505, 7507, 7513)
Cisco 7600 series routers (7603,
7606, 7609, 7613) with
FlexWAN or Enhanced
FlexWAN
1. For the Cisco 7206VXR router shelves in the Cisco AS5800, the interface specified in the above example would include a shelf number. For example,
the command interface pos 5/3/0 specifies the OC-3 interface of the PA-POS-1OC3 in port adapter slot 3 of router shelf 5.
OL-6514-04
provides example of the interface pos subcommand for the supported platforms.
Command
interface pos, followed by slot/port
(port-adapter-slot-number/
interface-port-number)
interface pos, followed by slot/port
(port-adapter-slot-number/
interface-port-number)
interface pos, followed by slot/port
(port-adapter-slot-number/
interface-port-number)
interface pos, followed by slot/port
(module-slot-number/
interface-port-number)
interface pos, followed by slot/port
(port-adapter-slot-number/
interface-port-number)
interface pos, followed by
slot/port-adapter/port
(interface-processor-slot-number/
port-adapter-slot-number/
interface-port-number)
interface pos, followed by
slot/port-adapter/port
(module-slot-number/
port-adapter-bay-number/
interface-port-number)
PA-POS-1OC3 Single-Port Port Adapter Installation and Configuration Guide
End with CNTL/Z.
Example
This example is for interface 0 of a
PA-POS-1OC3 in port adapter slot 6:
Router(config)# interface pos 6/0
Router(config-if)#
The example is for interface o of a
PA-POS-1OC3 in port adapter slot 1:
Router(config)# interface pos 1/0
Router(config-if)#
The example is for interface o of a
PA-POS-1OC3 in port adapter slot 1:
Router(config)# interface pos 1/0
Router(config-if)#
The example is for interface 0 on a port adapter
in a Cisco 7304 PCI Port Adapter Carrier Card
in module slot 3 of a Cisco 7304 router.
Router# interface pos 3/0
Router(config-if)#
The example is for interface 0 of a
PA-POS-1OC3 in port adapter slot 1:
Router(config)# interface pos 1/0
Router(config-if)#
The example is for interface 0 in port adapter
slot 1 of a VIP installed in interface processor
slot 1.
Router(config)# interface pos 1/1/0
Router(config-if)#
The example is for interface 0 on a port adapter
in port adapter bay 0 of a FlexWAN module in
module slot 3.
Router# interface pos 3/0/0
Router(config-if)#
Configuring the Interfaces
4-7
Advertisement
Table of Contents
