Table of Contents
Advertisement
Checking the Configuration
Using the show version or show hardware Commands
Display the configuration of the system hardware, the number of each interface type installed, the
Cisco IOS software version, the names and sources of configuration files, and the boot images using the
show version (or show hardware) command.
The outputs that appear in this document may not match the output you receive when running these
Note
commands. The outputs in this document are examples only.
The following sections provide output of the show version command for some of the supported
platforms:
•
•
•
•
Cisco 7200 VXR Routers—Example Output of the show version Command
Following is an example of the show version command from a Cisco 7206 VXR router with the
PA-POS-1OC3 installed:
Router# show version
Cisco Internetwork Operating System Software
IOS (tm) 7200 Software (C7200-JS-M), Version 12.3(10), RELEASE SOFTWARE (fc3)
Copyright (c) 1986-2004 by cisco Systems, Inc.
Compiled Mon 16-Aug-04 23:46 by kellythw
Image text-base: 0x60008AF4, data-base: 0x62014000
ROM: System Bootstrap, Version 12.3(4r)T1, RELEASE SOFTWARE (fc1)
Router uptime is 3 minutes
System returned to ROM by power-on
System image file is "disk2:c7200-js-mz.123-10"
cisco 7206VXR (NPE-G1) processor (revision A) with 491520K/32768K bytes of memory.
Processor board ID 26813737
SB-1 CPU at 700MHz, Implementation 1, Rev 0.2, 512KB L2 Cache
6 slot VXR midplane, Version 2.6
Last reset from power-on
Bridging software.
X.25 software, Version 3.0.0.
SuperLAT software (copyright 1990 by Meridian Technology Corp).
TN3270 Emulation software.
PCI bus mb1 (Slots 1, 3 and 5) has a capacity of 600 bandwidth points.
Current configuration on bus mb1 has a total of 0 bandwidth points. This configuration is
within the PCI bus capacity and is supported.
PCI bus mb2 (Slots 2, 4 and 6) has a capacity of 600 bandwidth points.
Current configuration on bus mb2 has a total of 300 bandwidth points. This configuration
is within the PCI bus capacity and is supported.
Please refer to the following document "Cisco 7200 Series Port Adaptor Hardware
Configuration Guidelines" on CCO <www.cisco.com>, for c7200 bandwidth points
oversubscription/usage guidelines.
3 Gigabit Ethernet/IEEE 802.3 interface(s)
1 Packet over SONET network interface(s)
509K bytes of non-volatile configuration memory.
125184K bytes of ATA PCMCIA card at slot 2 (Sector size 512 bytes).
PA-POS-1OC3 Single-Port Port Adapter Installation and Configuration Guide
4-14
Cisco 7200 VXR Routers—Example Output of the show version Command, page 4-14
Cisco 7201 Router—Example Output of the show version Command, page 4-15
Cisco 7301 Router—Example Output of the show version Command, page 4-15
VIP in Cisco 7500 Series Routers—Example Output of the show version Command, page 4-16
Chapter 4
Configuring the PA-POS-1OC3
OL-6514-04
Advertisement
Table of Contents
