H3C S12500 Series Manual page 19

Views
Any view
Predefined user roles
network-admin
network-operator
mdc-admin
mdc-operator
Parameters
interface-type: Specifies an interface type.
interface-number: Specifies an interface number.
interface-number.subnumber: Specifies a subinterface number, where interface-number is a main
interface (which must be a Layer 3 Ethernet interface) number, and subnumber is the number of a
subinterface created under the interface. The value range for the subnumber argument is 1 to 4094.
description: Displays the full description of the specified interface. If the keyword is not specified, the
command displays at most the first 27 characters of the interface description. If the keyword is specified,
the command displays all characters of the interface description.
Usage guidelines
If no interface type is specified, this command displays information about all interfaces.
If an interface type is specified but no interface number or subinterface number is specified, this
command displays information about all interfaces of that type.
If both the interface type and interface number are specified, this command displays information about
the specified interface.
Examples
# Display brief information about all interfaces.
<Sysname> display interface brief
The brief information of interface(s) under route mode:
Link: ADM - administratively down; Stby - standby
Protocol: (s) - spoofing
Interface
GE3/0/1
GE3/0/2
Loop0
NULL0
Vlan1
Vlan999
The brief information of interface(s) under bridge mode:
Link: ADM - administratively down
Speed or Duplex: (a)/A - auto; H - half; F - full
Type: A - access; T - trunk; H - hybrid
Interface
GE3/0/2
GE3/0/3
Link Protocol Main IP
UP UP 10.1.1.2
Stby DOWN --
UP UP(s) 2.2.2.9
UP UP(s) --
UP DOWN --
UP UP 192.168.1.42
Link Speed Duplex Type PVID Description
DOWN auto A
UP 100M(a) F(a)
13
Description
Link to CoreRouter
A 1
A 1 aaaaaaaaaaaaaaaaaaaaaaaaaaa