Table of Contents
Advertisement
1
Guide post
2
Groove
b) With the riser cards and connectors properly aligned, press down on the top of the PCIe cage to seat the riser cards
in their connectors.
c) Press down on the fastener and turn the fastener tab one half turn (180°) clockwise to secure the PCIe cage.
11. Install the controller into the chassis.
a) Make sure the controller release lever is fully extended.
b) Slide the controller into the chassis bay. Do not force the controller. If it does not slide in easily, remove it and try again.
c) After the controller is in place, return the controller release lever to its original closed position, and then tighten the
thumbscrews.
d) Reconnect all the network cables to the controller (as labeled from step 2).
e) Reconnect the power cables to both power supplies.
12. Verify that the controller is powered on.
After installation, the controller powers on automatically. The controller LEDs on the array remain on. If the controller does
not power on automatically, contact HPE Support.
Note: If firmware updates are required, the new controller can take longer to appear in the UI. If the controller
takes longer than 45 minutes to report an Active/Standby state, contact HPE Support for assistance.
3
Riser card
4
Connector
Documentation Feedback: doc-feedback-hpe-storage@hpe.com
Maintenance Procedures 67
Advertisement
Table of Contents
