HP HPE Alletra 6010 Hardware Manual page 90

• For the primary cage (left), proceed to Step 4.
• For the secondary cage (right), proceed to Step 5.
4. Remove the primary PCIe cage (left) from the controller.
a) Lift the tab of the fastener and turn the fastener one half turn (180°) counter clockwise to release the PCIe cage.
b) Grasp the PCIe cage with both hands and lift the cage out of the controller to unseat the underlying riser card from
its connector.
1 Fastener
2 Riser card
c) Turn the PCIe cage upside down and place it on a flat surface.
5. Remove the secondary PCIe cage (right), if present, from the controller.
Note: The HPE Alletra 6010 model does not include a secondary PCIe cage.
a) Lift the tab of the fastener and turn the fastener one half turn (180°) counter clockwise to release the PCIe cage.
b) Grasp both sides of the PCIe cage and lift the cage out of the controller.
Documentation Feedback: doc-feedback-hpe-storage@hpe.com
3 Connector
Upgrade Procedures 90