Summary of Contents for Glow Bricks Statue of Liberty Lego 21042
Page 2
Start by splitting the statue after detaching the lock from bottom...
Page 3
Take out the following lighting parts to install at the base Turn around the base and start installing from the back Install the lighting plates next to the connector first...
Page 4
Then install the remain lighting plates for the other 3 sides After installing 4 sides, take the blue brick, put the wire with connector in between the studs then restore the brick...
Page 5
Then take the spot light out from the corner Put the top back, then install the spot lights to 4 corners by this order Beware the last one should be installed on the side facing the back...
Page 6
Put the statue back to the base, then remove the following tan parts Switch the slopes on the lighting parts then install to the statue...
Page 7
Then pull the clear lighting round plate to the top For the bottom, remove the following parts...
Page 8
Install the lighting 1x3 plates, the one next to connector has to be on the back side Remove the dark tan tiles, hide the wires underneath after installing all the lights...
Page 9
At last, remember to lock the statue Connect with the USB cable then it’s done...
Need help?
Do you have a question about the Statue of Liberty Lego 21042 and is the answer not in the manual?
Questions and answers