Table of Contents
Advertisement
IMPORTANT! Read the following important safety information to avoid personal injury or
death, and to avoid damage to the equipment or property.
WARNINGS
To avoid any injury, turn the power switch
OFF unplug the unit from the power source
and
allow
to
cool
performing any maintenance and cleaning.
Plug unit into a properly grounded electrical
outlet of the correct voltage, size and plug
configuration. If the plug and receptacle do
not match, contact a qualified electrician to
determine the proper voltage and size and
install the proper electrical outlet.
To avoid electrical shock or personal injury,
do not steam clean or use excessive water on
the unit.
To prevent any injury or damage to the unit
do not pull unit by power cord.
To prevent any injury, discontinue use if
power cord is frayed or worn.
Unit is not waterproof. DO NOT submerge in
water. Do not operate if unit has been
submerged in water.
Some exterior surfaces on the unit will get
hot. Use caution when touching these areas
to avoid injury.
For safe and proper operation, the unit must
be located a minimum of 1" (25 mm) from
combustible walls and materials. If safe
distances are not maintained, discoloration or
combustion could occur.
Only light bulbs which meet or exceed NSF
standards, specifically designed for food
holding areas may be used. Breakage of light
bulbs not specially coated could result in
personal injury and/or food contamination.
If service is required on this unit, contact your
Authorized Hatco Service Agent, or contact
the Hatco Service Department at 800-558-
0607 or 414-671-6350; fax 800-690-2966 or
International fax 414-671-3976.
This product has no "user" serviceable parts.
To avoid damage to the unit or injury to
personnel, use only Authorized Hatco Service
Agents and Genuine Hatco Parts when
service is required.
IMPORTANT SAFETY INFORMATION
completely
before
Genuine Hatco Replacement Parts are
specified
to
environments in which they are used. Some
aftermarket or generic replacement parts do
not have the characteristics that will allow
them to operate safely in Hatco equipment. It
is essential to use Hatco Replacement Parts
when repairing Hatco equipment. Failure to
use Hatco Replacement Parts may subject
operators of the equipment to hazardous
electrical voltage, resulting in electrical shock
or burn.
Unit is not weatherproof. For safe and proper
operation, locate the unit indoors where the
ambient air temperature is constant and is a
minimum of 70°F (21°C).
To avoid any injury or damage, locate the unit
at the proper counter height, in an area that is
convenient for use. The location should be
level to prevent the unit or its contents from
accidentally falling, and strong enough to
support the weight of the unit and food.
Do not lay unit on the side with the control
panel or damage to unit could occur.
Use only non-abrasive cleaners. Abrasive
cleaners could scratch the finish of your unit,
marring its appearance and making it
susceptible to dirt accumulation.
1
operate
safely
in
CAUTIONS
NOTICE
Form No. GRSDSDBKM-0407
the
Advertisement
Table of Contents
