Remove The Security Bezel - Lenovo ThinkSystem SR150 Setup Manual

Installation procedures are presented in the optimum sequence to minimize work.
Attention: To ensure the components you install work correctly without problems, read the following
precautions carefully.
• Make sure the components you are installing are supported by the server. For a list of supported optional
components for the server, see
• Always download and apply the latest firmware. This will help ensure that any known issues are
addressed, and that your server is ready to work with optimal performance. Go to
to download firmware updates for your server.
Drivers and Software
• It is good practice to make sure that the server is working correctly before you install an optional
component.
• Follow the installation procedures in this section and use appropriate tools. Incorrectly installed
components can cause system failure from damaged pins, damaged connectors, loose cabling, or loose
components.

Remove the security bezel

Use this information to remove the security bezel.
Before removing the security bezel:
1. Read "Safety" on page iii
2. If the server is installed in a rack, extend or remove the server from the rack.
To remove the security bezel, complete the following steps:
Step 1. Use the key to unlock the security bezel to the open position.
Figure 24. Unlocking the security bezel
Step 2. Press the release latch and rotate the security bezel outward to remove it from the chassis.
Figure 25. Security bezel removal
https://static.lenovo.com/us/en/serverproven/index.shtml
and "Installation Guidelines" on page 32
.
ThinkSystem SR150
to ensure that you work safely.
.
Chapter 3 Server hardware setup
35