Step 2.
Tighten screw 1 and 2:
a.
Partially tighten screw 1.
b.
Fully tighten screw 2.
c.
Fully tighten screw 1.
Figure 45. Heat sink installation
Step 3.
Tighten screw 3 and 4:
a.
Partially tighten screw 3.
b.
Fully tighten screw 4.
c.
Fully tighten screw 3.
After you install the heat sink, complete the following steps:
1. Install the top cover onto the server (see
2. Install the server into the rack if necessary.
3. Reconnect power cords and all external cables.
Install the air baffle
Use this information to install the air baffle.
Before you install the air baffle, complete the following steps:
1. Read
"Safety" on page iii
"Install the top cover" on page
and
"Installation Guidelines" on page 32
54).
to ensure that you work safely.
.
Chapter 3
Server hardware setup
53