Install A Dimm - Lenovo ThinkSystem SR150 Setup Manual

To install the fixed power supply, complete the following steps:
Figure 39. Power supply unit installation
Step 1. Align the pins with the slots on the chassis; then, lower the power supply unit into the server.
Step 2. Slide the power supply unit backward to lock the pins into the slots.
Step 3. Install the screws that secure the power supply unit.
Step 4. Connect the internal power cable to system board, see
After you install the fixed power supply unit, complete the following steps:
1. Install the top cover onto the server (see
2. Install the server into the rack if necessary.
3. Reconnect power cords and all external cables.

Install a DIMM

Use this information to install a DIMM.
See "Memory module installation rules and order" on page 34
configuration and setup.
Before you install a DIMM, complete the following steps:
1. Read "Safety" on page iii
2. Remove the air baffle if necessary (see
3. Touch the static-protective package that contains the component to any unpainted metal surface on the
server; then, remove it from the package and place it on a static-protective surface.
The following illustration shows the system-board components, including DIMM connectors.
"Install the top cover" on page
and "Installation Guidelines" on page 32
"Remove the air baffle" on page
"Fixed power supply cables" on page
54).
for detailed information about memory
to ensure that you work safely.
37).
.
Chapter 3 Server hardware setup
24.
49