Installing the M.2 2280 solid-state drive
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the M.2 2280 solid-state drive and provides a visual representation of the
installation procedure.
Steps
1. Align the notch on the M.2 2280 solid-state drive with the tab on the solid-state drive slot.
2. Slide the M.2 2280 solid-state drive into the solid-state drive slot on the system board.
3. Align the screw holes on the M.2 2280 solid-state drive thermal plate with the screw holes on the system board.
4. Replace the two (M2x3) screws to secure the M.2 2280 solid-state drive thermal plate to the system board.
Next steps
1. Install the
base
cover.
2. Install the
microSIM
card.
3. Install the
microSD
card.
4. Follow the procedure in
Removing the M.2 2230 solid-state drive
Prerequisites
1. Follow the procedure in
2. Remove the
microSD
3. Remove the
microSIM
4. Remove the
base
cover.
after working inside your
before working inside your
card.
card.
computer.
computer.
Removing and installing components
25