Cisco Media Gateway Controller Node Manager Installation Manual page 42

Troubleshooting Common Installation Problems
Table 2-5
Problem
Cisco EMF Licensing
Cisco Media Gateway Controller Node Manager Installation Guide
2-30
Troubleshooting Installation Problems (continued)
Suggested Steps
After the Cisco EMF installation is completed, when you start the Cisco
, you may encounter a license problem. The reason for this is
EMF
that the default configuration of the Cisco EMF does not fully
support the Solaris 10 platform. Perform the following procedure
to resolve this problem.
If you encounter an error with Cisco EMF licensing when starting the
Cisco EMF, stop the license manager daemon and restart it by running the
following commands:
/etc/rc2.d/S98avlm stop
/etc/rc2.d/S98avlm start
If the problem is not resolved, check if a valid license has been uploaded into
/opt/cemf/config/licenses using the following procedure:
Add the following two lines in /opt/cemf/flexlm/avlm:
1.
ulimit -n 1024
ulimit -H -n 1024
2. Enter the following command to stop the lmgrd:
/opt/cemf/flexlm/lmdown
3. Enter the following command to restart the Cisco EMF:
/opt/cemf/bin/cemf start
Note The Cisco EMF licenses are fixed for a particular machine. You
cannot copy the license file from one machine to another. If you want
to install the Cisco EMF software on another machine, you must
contact Cisco support and ask for a new license. You are required to
provide Cisco support with the hostname and hostid of the new
machine.
Chapter 2 Installing Cisco MNM
OL-18332-04