1. Manuals
  2. Brands
  3. Cisco Manuals
  4. Network Card
  5. uBR10-SRP-OC12SML
  6. Instructions manual

Cisco uBR10-SRP-OC12SML Instructions Manual

Dpt wan line card for the cisco ubr10012 router
Hide thumbs
Table of Contents

Advertisement

Quick Links

Download this manual
Cisco uBR10-SRP-OC12SML DPT WAN Line Card
for the Cisco uBR10012 Router
78-13602-01
January 2002
This document describes the Cisco uBR10-SRP-OC12SML DPT WAN line card used in the
Cisco uBR10012 chassis. This document provides the following information:
•
•
•
•
•
•
•
•
Before using this product, see the translations for these warnings and other warnings that apply to
Note
this product in the
Warning
Class 1 laser product.
Because invisible laser radiation may be emitted from the aperture of the port when no
Warning
cable is connected, avoid exposure to laser radiation and do not stare into open
apertures.
Corporate Headquarters:
Cisco Systems, Inc., 170 West Tasman Drive, San Jose, CA 95134-1706 USA
Copyright © 2002. Cisco Systems, Inc. All rights reserved.
"Safety Information and Warnings" section on page
8.

Advertisement

Table of Contents
loading

Related Manuals for Cisco uBR10-SRP-OC12SML

Summary of Contents for Cisco uBR10-SRP-OC12SML

  • Page 1: Table Of Contents

    Cisco uBR10-SRP-OC12SML DPT WAN Line Card for the Cisco uBR10012 Router 78-13602-01 January 2002 This document describes the Cisco uBR10-SRP-OC12SML DPT WAN line card used in the Cisco uBR10012 chassis. This document provides the following information: Feature Overview, page 2 •...

  • Page 2: Feature Overview

    The Cisco uBR10-SRP-OC12SML DPT WAN line card requires two card slots. For that reason, the card is normally installed in Slot 2 and Slot 4 if you are using two cards. If you are using only one card than install the card in Slot 2, Slot 3 or Slot 4.
  • Page 3 Cisco uBR10-SRP-OC12SML DPT WAN Line Card for the Cisco uBR10012 Router Make sure that you obtain the correct connector type (SC/PC) when purchasing optical attenuators. Caution Angled SC/APC type mating surfaces can damage the Cisco uBR10-SRP-OC12SML DPT WAN line card (RX port) interface. “Connectors and Cables” section on page...

  • Page 4: Physical Description

    Ejector Lever CLEI code Ejector Lever The part number of the card (UBR10-SRP-OC12SML) is next to the CLEI code label. The label (2xOC-12/STM-4/SRP SM-LR) above the transmit and receive port connections defines the optical carrier specifications for this card. Figure 3...
  • Page 5 Cisco uBR10-SRP-OC12SML DPT WAN Line Card for the Cisco uBR10012 Router Table 1 describes the LEDs on the uBR10-SRP-OC12SML DPT WAN line card. Table 1 Cisco uBR10-SRP-OC12SML DPT WAN Line Card LEDs and Their Functions POWER STATUS - bi-color MAINTENANCE RX CARRIER–B...

  • Page 6: Connectors And Cables

    Connectors and Cables Connectors and Cables The Cisco uBR10-SRP-OC12SML DPT WAN line card uses a single-mode fiber-optic interface cable to connect the Cisco uBR10012 router to another router or switch. See Table 2 Cable Specification Fiber Type Single-mode fiber Single-mode cables are yellow.
  • Page 7 Cisco uBR10-SRP-OC12SML DPT WAN Line Card for the Cisco uBR10012 Router Connectors and Cables Figure 6 Attaching the Attenuator and Duplex Fiber-Optic Cables to the WAN Line Card Symplex cable Attenuator Duplex cable Attenuators Cisco uBR10-SRP-OC12SML DPT WAN Line Card...

  • Page 8: Safety Information And Warnings

    Übersetzungen der in dieser Veröffentlichung enthaltenen Warnhinweise finden Sie im Dokument Regulatory Compliance and Safety Information (Informationen zu behördlichen Vorschriften und Sicherheit) für den entsprechenden Cisco-Einbaurahmen. Cisco uBR10-SRP-OC12SML DPT WAN Line Card Cisco uBR10-SRP-OC12SML DPT WAN Line Card for the Cisco uBR10012 Router 78-13602-01...

  • Page 9: Installation Warning

    Cisco uBR10-SRP-OC12SML DPT WAN Line Card for the Cisco uBR10012 Router Avvertenza Questo simbolo di avvertenza indica un pericolo. La situazione potrebbe causare infortuni alle persone. Prima di lavorare su qualsiasi apparecchiatura, occorre conoscere i pericoli relativi ai circuiti elettrici ed essere al corrente delle pratiche standard per la prevenzione di incidenti.
  • Page 10 Router abgeschaltet wurde. Zur Vermeidung von Elektroschock Vorsicht bei der Arbeit in der Nähe von WAN-Ports. Beim Abtrennen von Kabeln zuerst das vom Router entfernte Ende lösen. Cisco uBR10-SRP-OC12SML DPT WAN Line Card Cisco uBR10-SRP-OC12SML DPT WAN Line Card for the Cisco uBR10012 Router 78-13602-01...

  • Page 11: Class 1 Laser Product Warning

    Cisco uBR10-SRP-OC12SML DPT WAN Line Card for the Cisco uBR10012 Router Avvertenza Nelle porte WAN sono presenti tensioni di rete pericolose, sia che il router sia acceso o meno (ON od OFF). Per evitare scosse elettriche, fare attenzione quando si lavora in prossimità...
  • Page 12 Do not look into the laser beam. Varning! Osynlig laserstrålning när denna del är öppen och förregleringen är urkopplad. Rikta inte blicken in mot strålen. Cisco uBR10-SRP-OC12SML DPT WAN Line Card Cisco uBR10-SRP-OC12SML DPT WAN Line Card for the Cisco uBR10012 Router 78-13602-01...

  • Page 13: Invisible Laser Radiation Warning

    Cisco uBR10-SRP-OC12SML DPT WAN Line Card for the Cisco uBR10012 Router Invisible Laser Radiation Warning Warning Because invisible laser radiation may be emitted from the aperture of the port when no cable is connected, avoid exposure to laser radiation and do not stare into open apertures.

  • Page 14: Electrical Equipment Guidelines

    ESD voltages on clothing can still cause damage. For safety, periodically check the resistance value of the antistatic strap. The measurement should be Caution between 1 and 10 megohms. Cisco uBR10-SRP-OC12SML DPT WAN Line Card Cisco uBR10-SRP-OC12SML DPT WAN Line Card for the Cisco uBR10012 Router 78-13602-01...

  • Page 15: About Removing And Replacing A Cisco Ubr10-Srp-Oc12Sml Dpt Wan Line Card

    Cisco uBR10-SRP-OC12SML DPT WAN Line Card for the Cisco uBR10012 Router About Removing and Replacing a Cisco uBR10-SRP-OC12SML DPT WAN Line Card Use the following procedure to install a new Cisco uBR10-SRP- OC12SML DPT WAN line card or to replace an existing line card. If two line cards are installed for redundant operation, you can remove one card and replace it without interrupting system operations.
  • Page 16 About Removing and Replacing a Cisco uBR10-SRP-OC12SML DPT WAN Line Card Removing the Line Card from the Chassis Attach an ESD preventative ground strap to your wrist and to a bare metal, unpainted surface on the chassis or frame. Face the back of the Cisco uBR10012 chassis. If necessary, clear enough interface and power cables to Step 1 allow sufficient space to work.
  • Page 17 Cisco uBR10-SRP-OC12SML DPT WAN Line Card for the Cisco uBR10012 Router Unscrew the top and bottom captive screws (4) on the Cisco uBR10-SRP- OC12SML DPT WAN line Step 3 card (Figure 7 on page Step 4 Simultaneously open both ejector levers on the front of the card.
  • Page 18 About Removing and Replacing a Cisco uBR10-SRP-OC12SML DPT WAN Line Card Pull the card out of the slot and place it on an anti-static surface or in an anti-static bag Step 5 Figure 9 Removing the Cisco uBR10-SRP- OC12SML DPT WAM Line Card from the Chassis...
  • Page 19 Cisco uBR10-SRP-OC12SML DPT WAN Line Card for the Cisco uBR10012 Router Replacing the Cisco uBR10-SRP-OC12SML DPT WAN Line Card Pick up the replacement Cisco uBR10-SRP- OC12SML DPT WAN line card and position it in front of Step 1 the card cage slot.
  • Page 20 About Removing and Replacing a Cisco uBR10-SRP-OC12SML DPT WAN Line Card Excessive transmit signal levels at the receiver port can damage the card. Receiver input Caution specifications are P Use an optical power meter to verify that receiver signal levels are within the specifications listed Step 5 = –29.0 dBm, P...

  • Page 21: About Troubleshooting The Cisco Ubr10-Srp-Oc12Sml Dpt Wan Line Card

    Cisco uBR10-SRP-OC12SML DPT WAN Line Card for the Cisco uBR10012 Router About Troubleshooting the Cisco uBR10-SRP-OC12SML DPT WAN Line Card Check the following items if a problem appears on one of the OC12SML DPT WAN line cards. Verify that the card is securely seated in the chassis Step 1 •...

  • Page 22: Technical Specifications

    Operating altitude Receiver sensitivity Transmitter output power Other information 1. British Thermal Units Cisco uBR10-SRP-OC12SML DPT WAN Line Card Cisco uBR10-SRP-OC12SML DPT WAN Line Card for the Cisco uBR10012 Router Specifications UBR-SRP-OC12SML= • ESR-LC-COVER= • Height: 16 in. (40.64 cm) •...

  • Page 23: Obtaining Documentation

    Cisco uBR10-SRP-OC12SML DPT WAN Line Card for the Cisco uBR10012 Router Obtaining Documentation Obtaining Documentation For information on obtaining documentation, submitting a service request, and gathering additional information, see the monthly What’s New in Cisco Product Documentation, which also lists all new and revised Cisco technical documentation, at: http://www.cisco.com/en/US/docs/general/whatsnew/whatsnew.html...

  • Page 24: Obtaining Technical Assistance

    SlideCast, SMARTnet, TransPath, Unity, Voice LAN, Wavelength Router, and WebViewer are trademarks of Cisco Systems, Inc.; Changing the Way We Work, Live, Play, and Learn, Discover All That’s Possible, and Empowering the Internet Generation, are service marks of Cisco Systems, Inc.; and Aironet, ASIST, BPX, Catalyst, Cisco, the Cisco...

Table of Contents