Table of Contents
Advertisement
VELBUS INSTALLATION GUIDE
As always, don't forget to synchronize (write) your project.
The feedback LED of the push button in the living room will now reflect the
state of the light in the children's room.
Other examples of possible LED feedback configurations are: showing the
status of a doorbell, a light in an out building, or even the status of a connected
burglar alarm (depending on hardware capability). These are all configured
following the same steps as described above.
FORCING AND INHIBITING
For many modules forcing and inhibiting actions are available.
Inhibiting
While inhibited, a channel will be turned off (released). During inhibition mode,
it will no longer respond to signals coming from the bus. It will however still
pick up these signals, and when coming out of inhibition mode, it will execute
the last command received, even if this was sent during inhibition mode.
For instance: relay channel 1 is inhibited from 23.00 until 23.30. At 23.20 it
receives an "on during 15 minutes" command. Result: the relay channel will be
©2015 Velbus
51
www.velbus.eu
Advertisement
Table of Contents
