Table of Contents
Advertisement
VELBUS INSTALLATION GUIDE
A window will pop up "Attempting to detect...". Press the physical button you
want to use, and its corresponding channel will be detected by Velbuslink.
If the detection does not seem to work, make sure the appropriate filters are
checked at the bottom of the "attempting to detect..." dialog. You can filter out
modules by unchecking the groups they belong to. This can be useful to ignore
modules that periodically put data on the bus (like temperature or movement
sensors) and that would otherwise appear without being activated by you. In
the example below the "Inputs", "Heating" and "Sensors" groups have been
deselected.
Here we have pressed the small button for channel 1 located on the relay
module itself (see image under "DIN rail relay modules" p.15).
Pressing "Accept" will fill in this channel in the "add action" dialog at the
appropriate place. You can then select the type of action you want to happen.
(Remember to modify any parameters in the right hand pane if necessary.)
VISUALIZING AND MODIFYING ACTIONS
By selecting any element of your installation (one or more modules or
channels) in the navigator (left hand pane of Velbuslink), the actions associated
with it will be shown in the right hand pane "Actions". To edit an action,
double-click on the name of the action and the "edit action" window will pop
©2015 Velbus
47
www.velbus.eu
Advertisement
Table of Contents
