Table of Contents
Advertisement
VELBUS INSTALLATION GUIDE
Clicking on the on/off buttons will actually operate the relay and you should
see the connected fixture be turned on or off. This way you can check which
channel is connected to which device from within Velbuslink, and rename it
accordingly.
Not only relay channels can be operated, but also push buttons, input
channels, dimmer channels, blind channels, and so on.
Renaming the modules and channels" on p.38).
BUS WIRING
Modules can be mounted anywhere along the four wire Velbus cable line.
At every joint the polarity of the power supply (+ and -) and data bus (H and L)
must be maintained! If mistakes are made in this respect, nothing will be
broken but your Velbus system will not work. Prevention is better than cure
so due attention should be paid in order to avoid problems later on.
©2015 Velbus
24
www.velbus.eu
Advertisement
Table of Contents
