Table of Contents
Advertisement
VELBUS INSTALLATION GUIDE
DIN RAIL SHUTTER MODULES
Every two shutters or screens require a
VMB2BLE 2-channel shutter controller. (As an
alternative to this DIN rail module, there is also
the VMB1BLS, a small 1-channel shutter
controller that easily fits in the shutter casing).
Shutters cannot be run in parallel, so each
shutter will require its own controller channel.
These modules can also control various
motorised platforms and moving devices, on a
timed movement basis.
DIN RAIL CONFIGURATION MODULE
In order to configure your Velbus system you will need a Velbus PC interface.
Through the interface modules you will be able to use the free configuration
software Velbuslink to program and monitor the Velbus modules.
The VMBRSUSB (shown here with its dust
protection cover removed) is a dual RS232 and
USB slave socketed version for installation onto
a DIN rail. (As an alternative to this DIN rail
module, there are also the VMB1USB and
VMB1RS interfaces for universal mounting
along the bus cable). Please note that the
VMBRSUSB only supports one connection type
at a time.
After having configured your Velbus installation, you will only need access to
this module when you want to make changes to the Velbus modules.
©2015 Velbus
17
www.velbus.eu
Advertisement
Table of Contents
