Table of Contents
Advertisement
Error Message Starting with "F"
When the error message starting with "F" is displayed, shut down DRYPRO 873 once and then restart
it. If DRYPRO 873 becomes inoperable due to some causes, restart DRYPRO 873.
To restart DRYPRO 873, perform the following steps.
1
Press the operation switch until a beep sounds (approximately one sec-
ond).
The message "Now shutting down Please wait a while" appears in the display win-
dow, and the status LED flashes.
The machine will be shut down in about 10 seconds.
2
Check that the machine has been shut down and then press and hold the
operation switch until a beep sounds (approximately one second).
When "Ready" appears in the display window after starting up the main unit, the
machine is ready to print.
When a PC Application Error Occurs
From the maintenance menu of the operation panel, enter the password and perform the system reset
described on the second screen.
"3.6.1 Enabling and Using Maintenance Mode" (page 54)
• If an error occurs, contact your Konica Minolta technical representatives.
When an F8700 Error Occurs
There may be a problem with PC.
1
If PC is stored below the main unit, open the lower cover, and press the
power switch for one second�
83
How to Clear Errors
1
2
3
4
5
6
7
8
9
1 0
1 1
1 2
Advertisement
Table of Contents
