Table of Contents
Advertisement
Film Related Settings
In the following cases, the supply tray will not open.
• When films are being printed
• When a different user is logged in from PC etc,
• The film size and type are displayed as values set for the target tray.
4
If there are films or paper trays inside the supply tray, remove them.
5
Check the attachment position of the film regulation pin�
Film regulation pin mounting
hole (14x14 in.)
Guide hole
Film regulation pin
mounting hole
14x17 in.
14x14 in.
11x14 in.
Do not place objects on the supply tray or lean on the supply tray
when it is pulled out� Failure to do so could cause fault�
Do not leave allen keys, film regulation pins, screws, or other items
inside the supply tray� Doing so could cause a failure�
The film regulation pins in the four corners of the supply tray are
fixed in place and cannot be changed�
"Please wait a while" is displayed, and the supply tray opens when printing has
completed.
press the [Service/Enter] button once again after that user has logged out.
Size of film to be used
Film regulation pin mounting
hole (11x14 in.)
Attachment position of film regulation pin
None (film regulation pin is not used)
74
Intermediate Plate
Advertisement
Table of Contents
